Bit Error Rate (BER) and Roll Off Factor

-
Roll Off  Factor

When a digital signal is modulated the output would be a waveform with the shape of sin(x)/x. Now this has an infinite bandwidth. So in order to be able to transmit this signal over satellite we need to filter it to reduce the occupied bandwidth. This is done by applying a "raised cosine roll-off filter". This filter is present both at the modulator output stage and at the input of the demodulator (I believe one says these filters are then matched). The steepness and the resulting occupied bandwidth can be set by the parameter roll-off factor. In DVB-S2 it can be 0.20 (20%); 0.25 (25%) or 0.35 (35%) where the 
Occupied bandwidth = symbol rate x (1 + roll-off factor).

Figure: Occupied bandwidth, Roll off factor and symbol rate 

Comments

Post a Comment

Popular posts from this blog

Symbol rate, Bandwidth and Bit rate Calculation

-
In satellite communication bandwidth (BW), symbol rate and bit rate are the most vital fact for proper signal transmission. There are many commercial software for BW, Symbol rate and bit rate calculation for TV signal transmission. But the equations of these parameter calculation are as follows. BW= (1+Roll of factor)* Symbol rate In general Roll of factor is 35% Symbol Rate =BW / (1+Roll of factor) and Bit Rate = Symbol rate * Modulation* FEC* (188/204)                                     [when 188 is encoder packet length] or Bit Rate = Symbol rate * Modulation* FEC* (204/188)                                     [when 204 is encoder packet length] Here, FEC = Forward Error Correction. In general FEC is in the range from 1/2 to 7/8. 188/204 = constant Unit ** BW= Hz, KHz, MHz, GHZ ** Symbol Rate= sps or baud, Ksps or Kbaud, Msps or Mbaud, Gsps or Gbaud ** Bit Rate= bps, Kbps, Mbps, Gbps Baud: U nit of signalling speed Baud rate: N umber of symbols transm
Read more

Azimuth and Elevation Angle for Satellite tracking

-
Image
Azimuth (Az) The earth station needs to know where the satellite is in the orbit. Then the earth station engineer needs to calculate some angles to track the satellite correctly. These angles are called antenna look angle. The look angles for the ground station antenna are the azimuth and elevation angles required at the antenna so that it points directly at the satellite. With the geostationary orbit the situation is much simpler than any other orbit. As the antenna beam width is very narrow and tracking mechanism is required to compensate for the movement of the satellite about the nominal geostationary position. Three pieces of information that are needed to determine the look angles for the geostationary orbit are a. Earth station latitude b. Earth station longitude c. Satellite orbital position Using these information antenna look angle can be calculated using Napier’s rule (solving spherical triangle). Azimuth angle denotes the horizontal angle measured a
Read more

Followers